在使用湖南升降机的过程中，也有很多隐藏的故障，在日常的保养和维修是不容易被察觉，如果这些故障没有解决，最终会导致整个设备瘫痪，有更严重的后果，所以在这个过程中的日常操作应注意这些风险，防患于未然，这就要求我们事先做好预防工作。下面是用户的操作往往忽视的细节。In the process of using the elevator in Hunan, there are a lot of hidden failures in daily maintenance and repair is not easy to detect, if the fault is not resolved, will eventually lead to paralysis of the entire equipment, have more serious consequences, so the daily operation in the process should pay attention to these risks, nip in the bud, the requires us to advance prevention work. Here are the details of the user's actions often overlooked.
1.湖南升降机不能下降到自然高度：该失败的原因是有太多的液压油;主题框架变形;有杂物在支撑杆。如果它是上面有几个原因，进行适当的排除。Hunan lift can not fall to the natural height: the reason for the failure is that there is too much hydraulic oil; subject frame deformation; there are debris in the support rod. If it is for several reasons above, make the proper removal.
2.按键失灵，湖南升降机设备的兴起，下降，暂停运营是通过按钮控制的，如果偶尔出现故障按钮的操作过程中应注意，这种现象可能是短路或即将发生的电力部门故障前兆，此时一定要及时，认真检查，防止整个设备的运行的未来影响。Key failure, the rise of Hunan elevator equipment declined to suspend operations through the button control, if occasionally should pay attention to the operation process of fault button, this phenomenon may be short or impending power sector before failure, this time must be timely, carefully check, prevent the running of the equipment of the future.
3.湖南升降机电机噪音，有时伴有发热电机或异味，造成这种情况的原因的问题如果有过载的问题，应该在时间被卸载..马达密封不良或线圈烧坏，此时被密封或更换线圈。电压不稳定，要检查电路是否是一个问题。Hunan elevator motor noise, sometimes accompanied by fever or motor odor, caused by the reasons for this problem if there is overload problem, should in time be unloaded. The seal is bad or coil burned out, at this time to be sealed or to replace the coil. Voltage instability, to check whether the circuit is a problem.
结论：湖南升降机隐藏的故障，发现问题及时消除，因此可以在许多故障的发生，因此小幅回调可能会避免发生故障，设备，稳定的和长期的操作继续。Conclusion: the fault of Hunan elevator hidden, found problems in a timely manner to eliminate, so in many faults, so a slight pullback may avoid failure, equipment, stable and long-term operation continues.